FYP2 - Week 13

Full view of the complete project

Inside view of the project

Output from the thermoelectric generator (TEG)

Output from the battery

Output from the transformer (Socket outlet)

FYP2 - Week 12

The major problem of this project was finding a method on how to generate high output voltage. At the early stage, study on thermoelectric power generator shows that the thermoelectric converts heat to electricity. In this project, the thermoelectric generator will be stick to the aluminium foil to absorb the heat from hot water. It will use a lot of thermoelectric generator in order to generate a larger voltage, as all the thermoelectric generator will connect in series connection.

FYP2 - Week 11

Title - flow chart

This is the flow chart of Development of Thermoelectric Power System for Renewable Energy project. Firstly, the heat from the hot water will flow into the aluminium foil (system) and straightly generate the electricity. Then, the voltage that produced will directly flow to the charging circuit. Next, the battery voltage is being detected to determine the status of the battery whether it is full or not. If not, the voltage that produced by the system will flow to battery charger hence charge the battery. There are only two conditions needed to be understood for this project. If the battery is less than 12V, the red LED is on and the green LED is off. The battery keeps on charging if the battery voltage is less than 12V and if battery voltage is over than 12V, then the battery will stop charging thus changing red LED to off and green LED to on condiotion. After that, if switch for the inverter circuit is turned ON, the battery energy will flow into the inverter circuit hence converting the voltage from DC voltage to AC voltage. Next, the transformer will step up the output voltage from 12V AC to 240V AC. After that, the socket outlet is ready to be used. 

FYP2 - Week 10

Title - Hardware testing

The project will be conducted for testing and experimental in order to testing the preformance and the ability of the charging circuit, inverter circuit, and thermoelectric generator to do it routine.

Charging circuit

Inverter circuit

Output from thermoelectric generator (TEG)

For the hardware testing, all circuit such as charging circuit, inverter circuit and thermoelectric generator (TEG) are perfectly functioning. The outputs of the circuit follow the design output before the hardware development